It started subtly. The living room radiator was lukewarm at the top but ice cold at the bottom. Then, the bedroom radiator went completely cold. The final straw was the boiler pressure dropping daily and the pipes making a sound like a boiling kettle. The giveaway? When I turned the heating on, one pipe to a radiator stayed stone cold while the other was hot.
Cold at bottom of rads = sludge. One pipe hot, one pipe cold = blockage. Drain, cut, vacuum for a DIY fix if you’re handy, but realistically, book a powerflush and fit a magnetic filter. Your boiler will thank you. Disclaimer: I am not a plumber. This is my experience as a homeowner. Always consult a Gas Safe engineer (UK) or licensed HVAC tech (US) before cutting into your heating system. blocked central heating pipes
I learned the hard way that central heating pipes don’t block with ice—they block with magnetite sludge (black iron oxide). Over time, oxygen in the water corrodes steel radiators and iron pipes. This creates a black, muddy sludge that circulates. It settles in low spots, narrow pipe bends, and—most commonly—inside the return pipe where water slows down. It started subtly
Before calling a plumber, check your system type. If you have microbore (small plastic or copper pipes like spaghetti), you are high risk. Those block permanently and often require full repiping. If you have standard 22mm/15mm copper, a powerflush will save you. The final straw was the boiler pressure dropping
